Axient Spectrum Manager delivers wide-band UHF spectrum scanning, spectrum analysis, and compatible frequency coordination in a single rack unit.
FEATURES
- Scans and analyzes the global UHF spectrum (470-952 MHz) in approximately one minute
- Continuously monitors, evaluates, and displays backup frequencies in real time
- Enables powerful RF protection features such as series automatic interference detection and avoidance via ShowLink™
- Compatible with Axient Digital and other Shure networked wireless systems, and works seamlessly with Wireless Workbench Software
- Easily connects to your computer or ShowLink Access Point via two Ethernet ports
- IEC in/out power ports enable daisy-chaining of AC power
RF Tuning Frequency Range 470 to 865, 925 to 952 MHz
RF Tuning Step Size 25, 200, and 1000 kHz
Scan Time The Spectrum Manager scans the entire RF tuning frequency range in 64 seconds using 8 scanning modules in parallel.
Scan time per 60 MHz may be less for specified ranges that allow scanning modules to work in parallel.
Step Size:
- 25 kHz: Max scan time per 60 MHz = 48 seconds
- 200 kHz*: Max scan time per 60 MHz = 7 seconds
- 1000 kHz*: Max scan time per 60 MHz = 1 second
*Available only with WWB6 control
- Noise Floor Resolution Bandwidth
- 25 kHz: -110 dBm
- 200 kHz: -100 dBm
- 1000 kHz: -90 dBm
- Image Rejection > 110 dB, typical
- Spurious Response < -100 dBm, typical
- Ultimate Quieting > 90 dB, A-weighted
- Housing Steel; extruded aluminum
- Power Requirements 100 to 240 VAC, 50-60 Hz
- Current Drain 0.8 A RMS (referenced at 120 VAC)
- Operating Temperature Range 0 to 145°F / -18 to 63°C
RF Input Specs
- Connector Type BNC
- Configuration Unbalanced, active
- Maximum Input Level -20 dBm
- Impedance 50 Ohms
- Bias Voltage 12 VDC, 150 mA (300 mA maximum)
Cascade Output
- Connector Type BNC
- Configuration Unbalanced, active
- Impedance 50 Ohms
- Insertion Loss < 5 dB
Monitor Output
- Audio Frequency Response 40 Hz to 18 kHz, ±3 dB
- Configuration 1/4" / 6.3 mm, unbalanced mono (will drive stereo headphones)
- Impedance 50 Ohms
- Maximum Signal Level 1 W @ 63 Ohms (45 kHz max deviation)
- Pin Assignments Tip: Audio +
- Ring: Audio +
- Sleeve: Ground
Networking
- PoE 50 VDC, Class 1
- Network Interface Dual port Ethernet 10/100
- Network Addressing Capability DHCP or manual IP address
Write a Review
Write a Review
×