No Sales Tax On Orders Shipped Outside of Florida
- Sennheiser MKH416 Shotgun Mic
- K-Tek KE-110CC Avalon Aluminum Coil Cabled Boompole (Length: 2'7" - 9'2")
- Rode Blimp Windshield w/ Rycote Shock Mount Suspension System
- Rode Dead Wombat Windjammer w/ Caring Brush
- TAI Audio XLRM - XLRF (RA) Coiled Cable, (Length: 3'-14')
- Sennheiser MZW-415 Foam Windscreen
- Sennheiser MZQ100 Mic Clip
- Sennheiser Microphone Case
The venerable MKH 416 is a compact pressure-gradient microphone with short interference tube, highly immune to humidity due to its RF condenser design. Featuring high directivity, low self noise, high consonant articulation and feedback rejection, the MKH 416 can handle difficult exterior filming and reporting conditions without any difficulty. Supercardioid/lobe pattern, matte black finish, supplied with the MZW415 windscreen.
The KE110CC Avalon Aluminum Boom Pole has a collapsed length of 2’7″ | 79cm and an extended length of 9’2″ | 279cm and only weighs 1.723lbs | 781g. This 5-section Aluminum Boompole features an Internal Coiled Cable. The top attachment is a 3/8″ – 16 male thread and the bottom attachment is a Male 3-pin XLR – Straight Exit.
Using the Avalon knurled collars on K-Tek’s well-known locking mechanisms trusted by industry professionals worldwide, this boom pole is easy to transport and quick to deploy.
K-Tek Avalon Aluminum: the economical alternative to Graphite
The K-Tek Avalon Aluminum poles are crafted of black anodized aluminum with a smooth finish, the Avalon aluminum poles extend and collapse with ease.
The Blimp Windshield and Rycote Shock Mount Suspension System from Rode is designed to provide your shotgun microphone with protection from wind noise and isolation from shock and vibration. The Blimp attaches to any standard boompole with the 3/8" thread attachment at the base. Housed inside the grip is a Mogami microphone cable which splits via a junction box to a flexible thin cable inside the Blimp, to minimize the transference of vibration to the microphone. Dead Wombat windshield, caring brush and tail/patch cable are included.
SENNHEISER MKH 416
Transducer Pressure Gradient/Interference Receiver Condenser Polar Pattern Supercardioid/Lobar Frequency Response 40 Hz - 20 KHz Dynamic Range (Typical) 117 dB Signal-to-Noise Ratio 81 dB Maximum Input Sound Level 130 dB, (@ 1 KHz)
Sensitivity 25 mV/Pa +/- 1dB
Power Requirements Phantom Power 48v, (± 12v) Output Impedance Nominal Impedance: 25 Ohms
Minimum Terminating Impedance: 800 Ohms
Output Connectors XLR-3M Type Pad None Low Frequency Roll-Off None Applications Film, Radio and Television, Especially for Outside Broadcast Applications. Dimensions 9.84 x 0.74 (250 x 19mm) LxDiameter Weight 5.82 oz. (175 g)
Material Graphite Sections 5 Minimum Length 2.02 to 8.9' (66 to 267cm) Maximum Length 2.02 to 8.9' (66 to 267cm) Weight 1.262 lbs (572g) Load Capacity Not Specified By Manufacturer